prevents chips and dirt into the bores and the slots

Double cone-collet for pneumatic chucks

Advantages:
– Clamping range +0,2 mm up to -0,8 mm
– Chip cover cap if technically possible, depends on type and ø
– This Alloy is not heat sensitive and very hard – non-abrasive
– High runout accuracy
– Prevents cold shut and friction between Material and guide bush
– Square and hexagon profiles are also available
– Special profiles according to you drawing can be eroded
– Suitable for all pneumatic guide-bush-systems

Pull-collet for pneumatic chucks

Advantages:
– Clamping range +0,2 mm up to -0,8 mm
– This Alloy is not heat sensitive and very hard – non-abrasive
– Prevents cold shut and friction between Material and guide bush
– High runout accuracy
– Square and hexagon profiles are also available
– Special profiles according to you drawing can be eroded
– Suitable for all pneumatic guide-bush-systems

Adjusting tool for Pull-collets and
spare parts like springs are also available.

Please feel free to contact us and ask for a free offer.